VPInstruments, manufacturer and worldwide supplier of measurement and monitoring equipment for compressed air and gas, now offers the proven VPLog-i current sensor in a new version with Modbus interface.
The VPLog-i-R is the only Rogowski type current sensor with RS485 (Modbus RTU) output.
You can now connect multiple VPLog-i-R sensors with other Modbus RTU devices to a PLC or smart data logger, for simultaneous data recording and analysis over a single modbus cable. Or connect the VPLog-i-R directly to your building/ energy management system for permanent energy monitoring.
The VPLog-i is the perfect device for mobile current measurements of e.g. compressors, vacuum pumps, driers, or any other electric equipment within your plant. Installation is very easy and takes you less than a minute; just wrap around one of the three-phase power cables and close the snap fitting. Moreover, due to the digital signal processing and extremely large measurement range of the VPLog-i-R, 100 to 1600 A RMS, you just need one size for all your measurement applications.
16.12.2020, VPInstruments
Should the content or the design of these sites violate third parties rights or legal prescriptions, we kindly ask you to send us a respective message without invoice or cost. We guarantee that passages where the claim is considered as justified will be removed immediately, without any necessity to involve any lawyer into this issue. We will reject any claim caused by submission of a honorary note in this regard without any prior contact and confirmation of the issueby us and we reserve the right ssue counter claim ourselves because of violation of aforesaid conditions.