Manufacturer of monocrystalline solar modules from Chemnitz prepares for the future by ordering two microCELL™ laser systems of the newest generation
By ordering two microCELL™ MCS systems for their plants in Thuringia and Chemnitz, Heckert Solar GmbH and LWD Solar GmbH are once again relying on production equipment with the quality seal “Made in Germany”. The MCS systems are a further development of the proven microCELL ™ TLS laser tools for half-cell production in photovoltaics. The microCELL ™ MCS systems will not only be able to cut half-cells with the high edge quality, which is typical for the TLS technology. They will also enable module manufacturers to react flexibly to larger cell formats and to cut the solar cells into thirds and quarters if required. With the microCELL ™ MCS systems, 3D-Micromac enables the processing of photovoltaic cells with a maximum cell size of up to 220 mm².
With this new order LWD Solar puts their trust in 3D-Micromac as a reliable and long-term partner when it comes to the expansion of their own module production and conversion to half-cell technology.
24.03.2021, 3D-Micromac
Should the content or the design of these sites violate third parties rights or legal prescriptions, we kindly ask you to send us a respective message without invoice or cost. We guarantee that passages where the claim is considered as justified will be removed immediately, without any necessity to involve any lawyer into this issue. We will reject any claim caused by submission of a honorary note in this regard without any prior contact and confirmation of the issueby us and we reserve the right ssue counter claim ourselves because of violation of aforesaid conditions.