The third episode of #AskGlaston Flat Tempering Series covers the challenges with the mixed production.
The common issue of mixed production is decreased loading table utilization and, therefore, reduced process efficiency. This is because combining different glass sizes in the same load requires accurate heating control and profound operator process knowledge. Lack of either of these usually results in underheating larger-size glasses or overheating the smaller ones. In turn, this leads to end product quality issues and unnecessary breakages.
Unlike any other convection technology in the market, Vortex Pro addresses the issue effectively. Without any operator input, Vortex Pro automatically creates individual convection profiles for each glass. Its convection uninterruptedly follows the glass movement in the heating section, allowing heat to be focused precisely to the specific point on each glass.
As a result, Vortex Pro has three major benefits:
Accurate and individual heat focusing for each glass
Decreased operator input to maintain constant high output quality
Reduced compressed air consumption, as the convection only targets the glass sheets
05.10.2022, Glaston
Should the content or the design of these sites violate third parties rights or legal prescriptions, we kindly ask you to send us a respective message without invoice or cost. We guarantee that passages where the claim is considered as justified will be removed immediately, without any necessity to involve any lawyer into this issue. We will reject any claim caused by submission of a honorary note in this regard without any prior contact and confirmation of the issueby us and we reserve the right ssue counter claim ourselves because of violation of aforesaid conditions.